MANUAL BIDET SEAT – INSTALLATION
CONNECTION TO A WATER SUPPLY
The Manual Bidet Seat needs a connection to a cold water supply. To connect the Manual Bidet Seat to an existent water supply in most of the installation cases you need a T-piece and a water hose. You can buy this set separately.
Grohe Accessory Set 14074000:
T-piece and hose
Dimensional drawing of the Grohe Accessory Set
Length of the hose: 795 mm
Connection: 3/8”
It depends on the type of your toilet and the conditions of your bathroom where the water connection point can be located. Here we show you examples of different installation situations. For a professional installation please ask your installer.
CLOSE-COUPLED WC
In case of a close-coupled WC, you can use the water supply e.g. of the cistern. Therefore you need a T-piece and a water hose. It is important to measure the distance from the water connection to the connection of the Manual Bidet Seat to see how long the water hose must be. Here you can find pictures of different installation situations:
Connection to the cistern water supply
Connection to the cistern water supply
Connection from water supply within the cistern
WALLHUNG / BACK TO WALL WC
If you have a wallhung or a back to wall WC, please have a look if you have an angle valve next to the toilet. In this case you can directly connect the Manual Bidet Seat to this angle valve.
If you have your washbasin nearby the toilet, you can connect the Manual Bidet Seat to the cold water supply.